Для машин выпусков 1993-2002гг коды самодиагностики трансмиссии двухзначные и выглядят так
46 Petrol: Intake manifold air control solenoid 2. Wiring, intake manifold air control solenoid. Diesel: Closed throttle position (CTP) switch. Wiring, CTP switch
49 Engine control module (ECM) - defective ECM
52 Module coding plug. Wiring, module coding plug
55 Input shaft speed (ISS) sensor/turbine shaft speed (TSS) sensor. Wiring, ISS/TSS sensor
56 323: Engine control module (ECM) - supply voltage.Wiring, ECM 626: Transmission fluid temperature (TFT) sensor Wiring, TFT sensor
57 Engine control relay Wiring, engine control relay
60 Shift solenoid (SS) A, 1-2 Wiring, SS
61 Shift solenoid (SS) B, 2-3 Wiring, SS
62 Shift solenoid (SS) C, 3-4 Wiring, SS
63 Torque converter clutch (TCC) control solenoid Wiring, TCC control solenoid
64 Shift timing solenoid, 3-2 Wiring, shift timing solenoid
65 Torque converter clutch (TCC) solenoid Wiring, TCC solenoid
66 Transmission fluid pressure (TFP) solenoid Wiring, TFP solenoid
67 Engine coolant blower motor relay - 1 /low temperature. Wiring, engine coolant blower motor relay
68 Engine coolant blower motor relay - high temperature. Wiring, engine coolant blower motor relay
69 Engine coolant blower motor temperature sensor. Wiring, engine coolant blower motor temperature sensor
71 Engine control module (ECM)/immobilizer control module - communication error. Wiring, immobilizer control module, ECM
72 Ignition key - not programmed into ECM ECM incorrectly/not programmed
73 Engine control module (ECM)/immobilizer control Incorrectly programmed immobilizer control module/ module - immobilizer codes do not match CM
74 Engine control module (ECM)/immobilizer control module - ignition key codes not match Incorrect/damaged key, ECM incorrectly programmed
75 Engine control module (ECM) - EEPROM error ECM
76 Engine control module (ECM) — immobilizer code not stored ECM incorrectly/not programmed
77 Immobilizer control module - communication error Incorrect/damaged key, wiring, reader coil, immobilizer control unit